Common defects and solutions of flexible circuit board in Zhanjiang

Flexible circuit board surface common defects and solutions  

1. Bubbles are formed after the sides of flexible circuit board or single line are expanded  

Main reason: air bubbles occur between two or more lines, mainly because the line spacing is narrow, the line is too high, so that the solder resist can not be printed on the substrate during screen printing, resulting in air or moisture between the solder and the substrate.  Gas thermal expansion during curing and exposure is mainly caused by overheight lines.  When the blade is in contact with the line, the included Angle between the scraper and the wire increases, so that the solder resist can not be printed to the root of the line, so that there is gas between the root of the weld and the weld resist layer, and bubbles are generated after heating.  

Solution: when screen printing, it is necessary to check whether screen material is completely printed on the substrate and the side wall of the line, and strictly control the current when electroplating.  

2. Flexible circuit board hole, with resistance welding and graph pinhole  

The main reason is: the flexible circuit board does not print paper in time in the screen printing process, resulting in excessive accumulation of residual ink in the screen, the residual ink is sent into the hole under the pressure of the scraper, and the number of screen is too small, it will also cause welding resistance in the hole.  Dirt on the photographic baseplate caused the flexible circuit board to fail to see light during exposure, resulting in pinholes in the pattern.  

Solution: timely use of high mesh printing paper and screen, exposure often check the cleanliness of the photo.  

3. The copper foil line under the resistance welding layer of the flexible circuit board appears black signs.  

Main cause: The flexible circuit board is not dried after wiping, and the surface of the printed circuit board is splashed by liquid or manual forming before printing resistance welding.  

Solution: Screen printing on both sides of the printed board copper foil oxidation phenomenon.